Stopping popup

Hi. Since 2 weeks I have a new problem. WinXP full.

Ends writing. save everything normally. push Exit. Scrivener disappears.
Then a popup appears " With the following signature…
Signature reads

AppName: scrivener.exe AppVer: ModName: qtcore4.dll
ModVer: Offset: 000f56b9

Then I could send this error to MSoft. with a bit of txt.
I suspect there must be a problem with new updates from MS.
Herewith the page with the problems intended for MS…
f57a_appcompat.txt (64.6 KB)

Thanks, I’ll forward this to Lee. I haven’t seen it, but I haven’t been on the XP machine lately. This started right after new standard updates from MS? I’ll try and give this a run later when I can get to the other computer. Are you able to open the program successfully after that with no problems to your project?

Yes, I can. :smiley: thanks for looking in the problem. I found that if I use the dropdown "File -> Exit. This problem does not occur.



No…this message up there:roll: is not right. I did a check and had the same problem again. The message window for MS oft.

Are you still getting this after uninstalling 029 and installing the new 035 beta?

MM, I did try to get this message again. Opened up a couple of dozen programs and everytime closingdown scrivener both in a crude way and gentle by the pulldown exit.
After 25 programs and a couple of fresh startups ( to be sure)

I was convinced!!! it works !!! No more popups. :smiley: :smiley: :smiley:

Great to hear! Thank you for the report.