Table and Cell width only in % ?

Hello,

I can setup the dell width only in %, in not possbile to set the width also in cm ?

thanks

Sorry, no. Due to the limitations of RTF, there aren’t a lot of options for this at present; even when there were some possibilities in setting the table up, it all ended saving one way in RTF and proved confusing. In future Lee plans to expand on this by adding his own code, but at the time being percentages are the only option. If you turn on the editor ruler and show the size of your printed paper, you can get a visual for how your table will look when compiled. Any further refinements at this point you’ll want to make in a word processor after you bring the piece out of Scrivener.

:frowning: